10

beagle software

< Prev     index     Next >

the printer is in the paper release mode before you install the ribbon cassette.

4. Open the printer cover by slightly pressing the ridges on the top left and pulling the cover forward, as shown in the illustration below.

5. Check to see that the ribbon in the cassette is not creased or twisted. Then turn the feed knob in the direction of the arrow on the ribbon cassette to take up any slack in the ribbon.

6. Carefully insert the ribbon cassette in the printer as shown in the illustration below. Notice exactly where the ribbon must go.

7. Then push firmly on the right side and then the left side of the ribbon cartridge until each side clicks into place.

8. To put the cover back on the printer, first align the left and insert the tab on the top; then press the bottom until it clicks into place.

Software Installation

To install DocuClock:

1. Remove the CD-ROM or floppies. If installing from floppies, write down the key code printed on the first floppy.
   

2. Place the CD-ROM in the drive.
   

3. From the Windows Start menu in the lower left corner select the  Run command from the menu
   

4. Enter  x:\setup  in the Open box where x is the drive letter used. Press OK
   

5. Follow the instructions from the installation wizard. For a typical installation you can accept all defaults offered by the wizard.
   

6. When asked for the key code, enter the key code you copied down (above) exactly as written in the Enter Code screen on the registration page, or if already in DocuClock choose the Register option under the Help menu.
   

7. If requested, you may need to reboot the system to install the new DLLs that were just installed.
   

8. When installation is complete, Start DocuClock from the
   Start/Programs/Beagle Software/DocuClock menu.