|
Software Installation
To install SlideShow:
Place the CD-ROM in the drive. Installation will start automatically when the CD-ROM drive is closed.
You can also start the CD-ROM manually. From the Windows Start menu in the lower left corner select the Run command from the menu
Enter x:\setup in the Open box where x is the drive letter used (typically D or E). Press OK
Follow the instructions from the installation wizard. For a typical installation you can accept all defaults offered by the wizard.
When asked for the key code, enter the key code you copied down (above) exactly as written in the Enter Code screen on the registration page, or if already in SlideShow choose the Register option under the Help menu.
Key codes are case sensitive.
If requested, you may need to reboot the system to install the new DLLs that were just installed.
When installation is complete, Start SlideShow from the
Start/Programs/Beagle Software/SlideShow menu.
SlideShow will inform you that it is initializing options for the first time.
Installing SlideShow options version X.X.X, for the first time
Note: If necessary you can install SlideShow directly over a previously installed version. Some SlideShow Options have changed so you may need to reset some time setting or display options after starting the new software.
|
|
